Channels and trendlines
Before looking for an entry, understand the market's direction. A channel shows the range of movement and where price sits within it; a trendline shows the relationship between highs or lows.
Change the slope. Compare at the same candle.
Set points A and B, then follow when the line appears and where price sits relative to it. Try a channel or a trendline, and edit the candles to distinguish a wick crossing, an outside close and a later return.
Change the points and candles
The selections are starting points. Editing A, B or channel width rebuilds the constructed background candles while retaining your edited D and R values; this is not historical data. The calculated slope or range changes, and candles are compared with it again. Editing pauses playback; future values describe the setup, not information already available.
Enter numbers from 1 to 1000000 and use a dot for decimals. For candles: high ≥ open and close; low ≤ open and close. Displayed readings are rounded to three decimals; comparisons use full values.
When does the line appear? How is price compared?
Both points are manual. Wait for two completed candles after each point to illustrate the difference between a point's location and when it becomes available. This is a teaching delay, not an automatic pivot detector or the indicator's own confirmation timing.
Compare price with the line or channel boundary at the current candle's position. Equality is not an outside close, and a wick alone is not a confirmed break under this rule. Extending a line continues its slope; it does not predict price.
This simulation uses independent teaching geometry between two points. Market Suite uses confirmed points for channels and lines; channels may update, freeze or be replaced under its own rules. Those private calculations and Wick/Body/Close options are not simulated here. The event describes what became visible, not an entry trigger or a guaranteed trend change.
Watch the episode (Arabic audio)
A channel has an upper and a lower boundary
Think of a channel as a corridor: an upper boundary, a lower boundary, and the space between them. If both slope upward, it is a rising channel. If they slope downward, it is a falling channel.
Ask two questions first: Is the channel rising or falling? and Where is price within it: near the top, bottom or middle?
Remember: price reaching a channel boundary alone is not an entry trigger. The channel marks areas where I watch price; it is not enough on its own to justify a trade.
A channel describes only the section it covers
This channel is rising. Does that mean the larger decline before it is over?
Draw a trendline yourself
A low is a point where price fell and then rose; a high is the reverse. Connect a low to a later higher low to draw an upward line. Connect a high to a later lower high to draw a downward line.
Select two circles to draw a trendline.
When comparing price with the line, look at the line's level directly below the current candle, rather than its distant endpoint. The extended part simply continues the slope; it is not a prediction that price must follow it.
The line appears after confirmation
A low's location differs from when it becomes confirmed. The earlier exercise below waits three candles after the second low to illustrate that delay; this is a teaching choice, not fixed Market Suite timing. The new simulation above uses two candles as a separate example. Advance the candles to see when the line appears:
Price above the line alone is not an instruction to buy. Moving below it alone is not enough to conclude that the entire trend has changed.
Test yourself
These charts are educational examples, not live prices or instructions to place a trade. Trading involves risk, and the decision is yours.